2.SETTING ITEMS (ADMIN)
SECURITY 111
2 SETTING ITEMS (ADMIN)
Performing the integrity check
This menu allows you to perform the following integrity check operations.
[MINIMUM]
Selecting [MINIMUM] checks the execution code to run the security function and the data to which the security
execution code refers.
[FULL]
Selecting [FULL] checks all execution codes and the data to which the security execution code refers.
1
On the SECURITY screen, press [INTEGRITY CHECK].
The INTEGRITY CHECK screen is displayed.
2
Press [MINIMUM] or [FULL].
The message “Are you sure ?” is displayed on the CONFIRMATION screen.
3
Press [OK].
When the integrity check is complete, the message “The process was finished successfully.” will be displayed on
the CONFIRMATION screen.
It may take some time to complete the integrity check.
When you press [OK] in the above screen while a job is being processed, the message “Process cannot be
performed while Job is processing or Admin function is in progress.” will be displayed on the CAUTION
screen. In this case, press [CLOSE], and wait until the job is complete, then perform the operation again.
Periodically perform the integrity check. If an error, such as illegally modified data, is detected, the service
call screen will be displayed. In this case, contact your service representative.
To Next Page
Loading...
Need help?
General
