Toshiba e-STUDIO2820C - Page 131

2
© 2008 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO2820C/2830C/3520C/3530C/4520C
SELF-DIAGNOSTIC MODE
2 - 105
[D] Setting
Perform the S-ACS operation setting referring to the table.
S-ACS operation setting <Copy>: (08)9934-0
S-ACS operation setting <Print>: (08)9934-1
S-ACS operation setting <Box>: (08)9934-2 (The setting value must be the same as that of <Print>.)
Since each value in the printing status is indicated as a guide to set the S-ACS operation, the setting
value does not have to correspond exactly.
Flow chart for determining setting values
Fig. 2-11
Setting value of the
S-ACS operation
setting
Printing status
Color rate MCV
S-ACS level
coefficient
Default setting of
the color mode
9
25% or less
5k or more
23 or more [Auto Color]
2 less than 5k
2 25 to less than 50%
-
17 to less than 23
[Black] /
[Auto Color] /
[Full Color]
2 or 1 50 to less than 75% 17 or less
1 75% or more 17 or less
MCV
Setting value
"1"
S-ACS operations setting
Determine each setting value with the color rate.
Color rate
50% or more 25% or less 5k or more
less than 5k25 to less
than 50%
When the default setting of color
modes is [Black] or [Full Color]
When the default setting of color
modes is [Auto Color]
Setting value
"9"
Setting value
"2"