Toshiba e-STUDIO2820C - Finisher Firmware (MJ-1031)

e-STUDIO2820C/2830C/3520C/3530C/4520C © 2008 TOSHIBA TEC CORPORATION All rights reserved
FIRMWARE UPDATING
8 - 42
8.3.7 Finisher firmware (MJ-1031)
Important:
• Be sure to shut down the equipment before installing and removing the download jig.
• Do not shut down the equipment during the update. The data could be damaged and not be
operated properly.
[A] Update Procedure
(1) Install the ROM to the download jig (K-PWA-DLM-320).
Make sure the direction is correct.
(2) Press the [ON/OFF] button on the control panel to shut down the equipment.
(3) Take off the hanging finisher (MJ-1031) from the equipment.
Fig. 8-43
(4) Take off the rear cover.
Fig. 8-44