e-STUDIO2820C/2830C/3520C/3530C/4520C © 2008 TOSHIBA TEC CORPORATION All rights reserved
REPLACEMENT OF PC BOARDS/HDD
7 - 20
7.2.4 Procedures and Precautions when replacing the SYS board
Note:
When you replace the SYS board while the data encryption function is enabled, readout of the
user data/information stored in the HDD becomes impossible.
A procedure for replacing the SYS board is shown below.
Fig. 7-33
Start
[A] Replace DIMM and SRAM
[B] Update system ROM version
[C] Initialize SRAM
[D] Enable HDD encryption
[E] Check ROM versions
[F] Initialize settings
[G] Format HDD
[H] Adjust image quality
[I] Set dial type
[J] Set date and time
[K] Set EFI Printer Board
[M] Clear SRAM
[L] Reinstall options
Setting completed
To Next Page
Loading...
