Toshiba e-STUDIO2820C - Adjustment of the Doctor-To-Sleeve Gap

e-STUDIO2820C/2830C/3520C/3530C/4520C © 2008 TOSHIBA TEC CORPORATION All rights reserved
ADJUSTMENT
3 - 72
3.9 Adjustment of the doctor-to-sleeve gap
For the adjustment of the doctor-to-sleeve gap, perform the same procedure for the Y, M, C and K
developer units.
Adjustment tool to use: Doctor-sleeve gap jig
<Adjustment procedure>
(1) Take off the process unit from the equipment.
(2) Take off the developer unit from the process
unit.
 SERVICE MANUAL "12.6 Disassembly
and Replacement"
(3) Take off the developer material cover. Then
discharge the developer material.
Note:
While reattaching the developer material
cover set the latches securely.
Fig. 3-32
(4) Loosen 2 doctor blade fixing screws. Insert
the gauge “0.65” of the doctor sleeve jig
between the developer sleeve and doctor
blade to adjust the gap, and tighten the
screws.
Fig. 3-33
Developer material cover
Developer unit
Doctor blade