e-STUDIO2820C/2830C/3520C/3530C/4520C © 2008 TOSHIBA TEC CORPORATION All rights reserved
ERROR CODE AND TROUBLESHOOTING
6 - 8
6.1.2 Service call
ED16 Finisher jam
(Finisher section)
Buffer tray home position error: The buffer tray is
not at the home position. [MJ-1101]
P. 6 - 5 2
Error code Classification Contents Troubleshooting
C040 Paper feeding system
related service call
PFP motor abnormality: The PFP motor is not rotat-
ing normally. (the case that paper can be fed from
any drawer except the PFP)
P. 6 - 5 3
C130 1st drawer tray abnormality: The tray-up motor is
not rotating or the 1st drawer tray is not moving nor-
mally. (the case that paper can be fed from any
drawer except the 1st drawer)
P. 6 - 5 4
C140 2nd drawer tray abnormality: The tray-up motor is
not rotating or the 2nd drawer tray is not moving
normally. (the case that paper can be fed from any
drawer except the 2nd drawer)
P. 6 - 5 4
C150 PFP upper drawer tray abnormality: The PFP upper
drawer tray-up motor is not rotating or the PFP
upper drawer tray is not moving normally. (the case
that paper can be fed from any drawer except the
PFP upper drawer)
P. 6 - 5 5
C160 PFP lower drawer tray abnormality: The PFP lower
drawer tray-up motor is not rotating or the PFP
lower drawer tray is not moving normally. (the case
that paper can be fed from any drawer except the
PFP lower drawer)
P. 6 - 5 5
C180 LCF tray-up motor abnormality: The LCF tray-up
motor is not rotating or the LCF tray is not moving
normally. (the case that paper can be fed from any
drawer except the LCF)
P. 6 - 5 6
C1A0 LCF end fence motor abnormality: The LCF end
fence motor is not rotating or the LCF end fence is
not moving normally. (the case that paper can be
fed from any drawer except the LCF)
P. 6 - 5 7
C1B0 LCF transport motor abnormality: The LCF trans-
port motor is not rotating normally. (the case that
paper can be fed from any drawer except the LCF)
P. 6 - 5 8
C260 Scanning system
related service call
Peak detection error: Lighting of the exposure lamp
(white reference) is not detected when power is
turned ON.
P. 6 - 5 8
C270 (1) Carriage home position sensor not turning OFF
within a specified period of time: The carriage does
not shift from its home position in a specified time.
(2) Downloading firmware with an incorrect model.
P. 6 - 5 9
C280 Carriage home position sensor not turning ON
within a specified period of time: The carriage does
not reach to its home position in a specified period
of time.
P. 6 - 5 9
Error code Classification Contents Troubleshooting
To Next Page
Loading...
