Toshiba e-STUDIO2820C - Maintenance Part List

5
© 2008 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO2820C/2830C/3520C/3530C/4520C
PREVENTIVE MAINTENANCE (PM)
5 - 33
5.8 Maintenance Part List
The parts used for the maintenance of this equipment are as follows.
No. Item Purpose
Parts list
<P-I>*
1 Cleaning brush Cleaning inside of the equipment 101-2
2 Doctor blade cleaning jig Cleaning the doctor blade 101-3
3 Wire holder jig Fixing the wire at the assembly of the carriage wire 101-4
4 Developer material nozzle Pouring the developer material (attached to the devel-
oper bottle)
101-5
5 Doctor-sleeve jig Measuring the gap between the development sleeve
and the doctor blade
101-6
6 Belt tension jig Adjusting the belt tension at the installation of the
scan motor
101-7
7 Separation plate gap jig Measuring the gap between the separation plate and
the fuser belt
101-8
8 Drum bag Storing the drum 101-10
9 Download jig (DLM board) Updating the scanner/options ROM 102-1
10 ROM Installing the DLM board 102-10
11 Download jig-2 (6 Flash ROMs) Updating the system/engine/scanner ROM 102-2
12 ROM writer adapter (For 1881) Writing the data of PWA-DWNLD-350-JIG2 102-4
13 ROM writer adapter (For 1931) Writing the data of PWA-DWNLD-350-JIG2 102-5
*: Part list <P-I> represents the page item in "e-STUDIO2820C/2830C/3520C/3530C/4520C Ser-
vice Parts List".