Toshiba e-STUDIO2820C

To Next Page

To Previous Page

ADJUSTMENT

3 - 47

1. While pressing [0] and [5] simultaneously, turn the power ON. Æ Adjustment Mode

2. Select the A4/LT drawer. Key in the pattern number and press the [FAX] button to output a “Patch

chart for adjustment”.

Note:

However, this is applied to all paper types when 05-1008 is performed.

3. Place the patch chart for adjustment printed in step (2) face down on the original glass, with its side,

on which two black squares are present, aligned against the original scale.

4. Key in a code and press the [START] button. Æ The scanner reads the chart automatically and per-

forms automatic gamma adjustment calculation (approx. 30 sec.).

5. When the adjustment has finished normally, “ENTER” is shown.

Press the [ENTER] button to have the adjustment results reflected.

(To cancel the reflection of adjustment results, press the [CANCEL] button.)

In the case of an abnormal ending, “ADJUSTMENT ERROR” is shown. Press the [CANCEL] button

to clear the error display.

When it is cleared, the control panel display will return to the ready state. Then, check if the patch

chart on the original glass is placed in the wrong direction or if it is placed inclined on the original

glass, and then repeat step (3) and afterward.

Pattern No. Paper type Remarks

70 Plain paper Used when the code 1004-0 is performed

74 Recycled paper Used when the code 1004-2 is performed

76 Thick paper 1 Used when the code 1004-3 is performed

78 Thick paper 2 Used when the code 1004-4 is performed

80 Thick paper 3 Used when the code 1004-5 is performed

82 Thick paper 4 Used when the code 1004-6 is performed

84 Special paper 1 Used when the code 1004-7 is performed

86 Special paper 2 Used when the code 1004-8 is performed

Code Remarks

08-9059 0: No paper selecting buttons displayed

1: Paper selecting buttons displayed. (For both Copy and Printer)

Toshiba e-STUDIO2820C - Page 179