4
© 2008 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO2820C/2830C/3520C/3530C/4520C
BACKUP FUNCTION
4 - 9
(5) Press the [START] button. The restore starts and the restoring status is displayed on the LCD
screen.
(6) "Restore Completed" is displayed on the LCD screen when restoring has been properly com-
pleted.
(7) Turn the power OFF and remove the USB media.
*When "department management data" or "user management data" are restored, clear their
counter values in a procedure below.
(8) Counter values can be all cleared as the data are copied. Note that the total counter values are
not copied.
<Procedure>
Press the buttons as follows: [USER FUNCTIONS] [ADMIN] Enter the password
[COUNTER] [DEPARTMANT SETTING] Enter the password [RESET ALL
COUNTERS]
*Enable the department management when the [RESET ALL COUNTERS] buttons is set to be
disabled.
To Next Page
Loading...
