6
© 2008 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO2820C/2830C/3520C/3530C/4520C
ERROR CODE AND TROUBLESHOOTING
6 - 85
[CCD0] Stack ejection motor abnormality
[CCE0] Rear end assist motor abnormality
[CCF0] Gear change motor abnormality
MJ-1030
Is the shutter home position sensor (PI45) normal?
NO Replace the sensor.
YES
Are the wirings between the finisher controller PC board and the stack ejection motor (M32)/
shutter clutch (CL31) correct?
NO Correct the wirings.
YES
Is there any problem with the shutter mechanism?
YES Fix the shutter mechanism.
NO
1. Replace the stack ejection motor and shutter clutch.
2. Replace the finisher controller PC board.
MJ-1030
Is the rear end assist guide home position sensor (PI39) normal?
NO Replace the sensor.
YES
Is the wiring between the finisher controller PC board and the rear end assist motor (M39) cor-
rect?
NO Correct the wiring.
YES
Is there any problem with the rear end assist mechanism?
YES Fix the rear end assist mechanism.
NO
1. Replace the rear end assist motor.
2. Replace the finisher controller PC board.
MJ-1030
Is the gear change home position sensor (PI49) normal?
NO Replace the sensor.
YES
Is the wiring between the finisher controller PC board and the gear change motor (M40) cor-
rect?
NO Correct the wiring.
YES
Is there any problem with the gear change mechanism?
YES Fix the gear change mechanism.
NO
1. Replace the gear change motor.
2. Replace the finisher controller PC board.
To Next Page
Loading...
