Toshiba e-STUDIO2820C - Page 453

8
© 2008 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO2820C/2830C/3520C/3530C/4520C
FIRMWARE UPDATING
8 - 35
(3) Remove 1 screw and take off the finisher board access cover.
Fig. 8-33
(4) Release the latches and take off the rear lower cover of the hole punch unit.
Fig. 8-34
(5) Remove 3 screws and take off the rear cover of the hole punch unit.
Fig. 8-35
Board access cover
Rear lower cover
Rear cover