8
© 2008 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO2820C/2830C/3520C/3530C/4520C
FIRMWARE UPDATING
8 - 39
(5) Change the setting of the DIP switch on the finisher control PC board.
Change the setting of the DIP switch as follows according to the firmware to be updated.
Note:
Record the current settings of the DIP switch before changing them. After the updating is com-
pleted, return the DIP switch to the status as record.
Fig. 8-41
DIP switch Updating Finisher Firmware Updating Saddle Stitcher Firmware
1OFF OFF
2OFF OFF
3OFF OFF
4OFF OFF
5OFF OFF
6OFF OFF
7OFF ON
8OFF ON
To Next Page
Loading...
