4. Cautionary Labels
- During servicing, be sure to check the rating plate and cautionary labels such as “Unplug the
power cable during service”, “CAUTION. HOT”, “CAUTION. HIGH VOLTAGE”, “CAUTION.
LASER BEAM”, etc. to see if there is any dirt on their surface and if they are properly stuck to the
equipment.
5. Disposal of the Equipment, Supplies, Packing Materials, Used Batteries and IC-RAMs
- Regarding the recovery and disposal of the equipment, supplies, packing materials, used batter-
ies and IC-RAMs including lithium batteries, follow the relevant local regulations or rules.
6. When the option has been installed:
When the EFI printer board has been installed, be sure to unplug the power cable before performing
maintenance and inspection, otherwise troubles such as a communication error may occur.
Caution:
Dispose of used batteries and IC-RAMs including lithium batteries according to this manual.
Attention:
Se débarrasser de batteries et IC-RAMs usés y compris les batteries en lithium selon ce manuel.
Vorsicht:
Entsorgung der gebrauchten Batterien und IC-RAMs (inclusive der Lithium-Batterie) nach diesem Handbuch.
Explanatory label
Warning for grounding wire
Warning for
high temperature area
(
fuser unit
)
Warning for
high temperature area
(
fuser unit
)
Warning for
high temperature area
(
ventilation holes
)
Identification label
Certification label
Warning for high temperature area
Warning for handling transfer belt
To Next Page
Loading...
