November 2003 Ā© TOSHIBA TEC 3 - 23 e-STUDIO3511/4511 ADJUSTMENT
Note:
Be sure that this adjustment be made after performing "3.5.1 Automatic gamma adjustment".
<Procedure>
(1) While pressing [0] and [5] simultaneously, turn the power ON.
(2) Key in a code and press the [START] button.
(3) Key in an adjustment value (acceptable values: 0 to 255).
(To correct the value once keyed in , press the [CLEAR] button.)
(4) Press the [ENTER] or [INTERRUPT] button to store the value. ā The equipment goes back to
the ready state.
(5) Press the [FAX] button and then press the [START] button to make a test copy.
(6) If the desired image has not been attained, repeat step (2) to (5).
To Next Page
Loading...
