Toshiba e-STUDIO3511 - Adjusting the Angle of the Jogging Plate

e-STUDIO3511/4511 ADJUSTMENT 3 - 72 November 2003 © TOSHIBA TEC
3.13.2 Adjusting the angle of the jogging plate
(3) With reference to the rear jogging plate
adjusted in step (2), adjust the front jogging
plate in the same manner.
Screw Rear jogging plate
Fig. 3-1306
Fig. 3-1307
Paper
Butted
0 mm to 0.5 mm
Screw
Rear jogging
plate
(1) Without removing the processing tray unit,
loosen the 2 mounting screws of the rear
jogging plate.
(2) Place several sheets of A4/LT paper on the
processing tray, and adjust the rear jogging
plate. (At this time, adjust the gap between
the paper and the front end of the rear
jogging plate so that it is 0 mm to 0.5 mm.)