e-STUDIO3511/4511 REMOTE SERVICE 8 - 2 November 2003 © TOSHIBA TEC
7
8.1.2 Setting Item
To enable Auto Supply Order, the following settings are required.
Note: When selecting E-mail to place an order, it is required that sending and receiving E-mails are
available. Confirm the details to the administrator.
(1) Self-diagnosis (08) Setting
As the default setting, the Auto Supply Order setting screen is not displayed on the touch panel.
To display it, switching the Valid/Invalid setting (08-765) is required.
0: Valid (FAX/Internet FAX)
1: Valid (FAX/Internet FAX/HTTP)*
2: Invalid (Default)
When changing the setting value from "2" (default) to "0", the Auto Supply Order setting screen is
displayed. (* HTTP has not been supported yet.)
(2) Touch Panel Setting
Each item is set from the Auto Supply Order screen on the touch panel.
Entering the password and customer information is required because the setting is made from the
ADMIN screen. Setting it with the administrator is a must.
(2-1) Basic setting
[ADMIN] > [SERVICE] > [SUPPLY ORDER SETUP] > [ORDER INFORMATION]
AUTO SUPPLY ORDER
FAX NUMBER
E-MAIL
CUSTOMER
NAME
TEL NUMBER
E-MAIL
ADDRESS
SUPPLIER
NAME
ADDRESS
SERVICE TECNICIAN
NUMBER
NAME
TEL NUMBER
E-MAIL
Ordered by: [FAX], [MAIL], [HTTP] (*1)
FAX number of supplier (*2)
E-mail address of supplier (*3)
Customer information
Supplier information
Service technician information
*1 HTTP has not been supported yet.
*2 Even when "FAX" is selected, the order is not placed without entering the FAX number.
*3 Even when "MAIL" is selected, the order is not placed without entering the E-mail address.
04/05
To Next Page
Loading...
