Toshiba e-STUDIO3511 - Adaptation to Highlighter

e-STUDIO3511/4511 ADJUSTMENT 3 - 30 November 2003 © TOSHIBA TEC
3.5.11 Adaptation to highlighter
Four modes of one touch adjustment are performed and each mode can be switched into two modes;
highlighter 1 or 2. This adjustment is performed when the reproduction mode for highlighter is needed.
Code
1769
1770
1771
1772
Remarks
0: Default (Vivid / Clear / Warm / Cool)
1: Highlighter 1
2: Highlighter 2
One touch adjustment
Vivid
Clear
Warm
Cool
Make a test copy and compare the image obtained with the current settings; if necessary, make
adjustment using the following procedure.
<Procedure>
Procedure is same as that of “3.5.3 Color balance adjustment”.
Notes:
1. When this adjustment is performed, “3.5.1 Automatic gamma adjustment (Black Mode)” (05-580)
needs to be performed since the reproduction of density at Black Mode varies. The result of this
adjustment is not reflected to color/black integrated pattern. Namely, each automatic gamma
adjustment of Black Mode (05-580) or of Color Mode (05-1643) needs to be performed individually
after this adjustment.
2. After this adjustment, set “1” in 08-595 so that the correction result of the Black Mode is not reflected
on “Automatic Calibration”.
3. The setting value must increase as the beam level number (0 to 4) becomes higher. Do not increase
this order when setting the values.
4. Usually, beam level 4 is most effective on all black modes.
Code
667-0
667-1
667-2
667-3
667-4
Remarks
The smaller the value is, the smaller the beam width
becomes. Therefore, the smaller dot is reproduced
accordingly. Acceptable values: 0 to 255.
(Default: Level 0/4: 0, Level 1/4: 63, Level 2/4: 127,
Level 3/4: 191, Level 4/4: 255)
Item to be adjusted
Beam level 0/4
Beam level 1/4
Beam level 2/4
Beam level 3/4
Beam level 4/4
Note:
The color may not always be reproduced precisely due to the characteristics of fluorescent ink.
3.5.12 Beam level conversion setting
The beam level for 4 divided smoothing is set at the Black Mode. This adjustment enables to adjust
the dot size.
<Adjustment Mode (05)>
<Adjustment Mode (05)>