e-STUDIO3511/4511 ADJUSTMENT 3 - 92 November 2003 © TOSHIBA TEC
05/03
3.16.3 Adjustment procedure
(1) Check if there is no abnormality in the
installation of the equipment.
(2) Take off the drum cleaner unit.
(3) Take off the black developer unit.
(4) Turn the releasing lever clockwise to lower
the transfer belt unit.
(5) Tighten 2 screws that were loosened when
the drum cleaner unit was taken off.
(6) Tighten 2 screws.
Fig. 3-1602
Fig. 3-1603
Fig. 3-1604
To Next Page
Loading...
