Toshiba e-STUDIO3511 - One-Touch Adjustment

e-STUDIO3511/4511 ERROR CODE AND SELF-DIAGNOSTIC MODE 2 - 78 November 2003 © TOSHIBA TEC
200
201
202
203
204
205
206
5
1
1
1
1
1
1
General
General
User
interface
General
User
interface
User
interface
User
interface
Date and time setting
Destination selection
Counter installed externally
Line adjustment mode
Auto-clear timer setting
Auto power save mode timer
setting
Auto Shut Off Mode timer
setting (Sleep Mode)
ALL
ALL
ALL
ALL
ALL
ALL
ALL
-
<13 digits>
EUR: 0
UC: 1
JPN: 2
<0-3>
0
<0-4>
0
<0-1>
3
<0-10>
11
<0, 6-15>
Refer to
content
<0-20>
-
M
M
M
SYS
SYS
SYS
Year/month/date/day/hour/minute/
second
Example: 03 07 0 13 13 27 48
“Day” - “0” is for “Sunday”. Proceeds Mon-
day through Saturday from “1” to “6”.
0: EUR 1: UC
2: JPN 3: Other
0: No external counter
1: Coin controller
2: Copy key card
3: Key copy counter
4: Key card for OEM1
0: For factory shipment 1: For line
*Field: “0” must be selected
Timer to return the equipment to the
default settings when the [START]
button is not pressed after the
function and the mode are set
0: Not cleared
1 to 10: Set number x 15 sec.
Timer to automatically switch to the
energy saving mode when the
equipment has not been used
0: Invalid 6: 3min. 7: 4min.
8: 5min. 9: 7min. 10: 10min.
11: 15min. 12: 20min. 13: 30min.
14: 45min. 15: 60min.
Timer to enter the Sleep Mode
automatically when the equipment
has not been used
0: 3min. 1: 5min. 2: 10min.
3: 15min. 4: 20min. 5: 25min.
6: 30min. 7: 40min. 8: 50min.
9: 60min. 10: 70min. 11: 80min.
12: 90min. 13: 100min. 14: 110min.
15: 120min. 16: 150min. 17: 180min.
18: 210min. 19: 240min.
20: Not used
<Default value>
e-STUDIO3511: 9
e-STUDIO4511: 12
Setting mode (08)
Code
Classifi-
cation
Items
Func-
tion
Default
<Acceptable
value>
RAM Contents
Proce-
dure
Notes:
1. The digit after the hyphen in “Code” of the following table is a sub code.
2. In “RAM”, the NVRAM of the board in which the data of each code is stored is indicated. “M” stands for
the LGC board, “SYS” and “UTY” stands for the SYS board and “NIC” stands for the NIC board.
04/09