Toshiba e-STUDIO3511 - Printing Stored Documents

November 2003 © TOSHIBA TEC 3 - 29 e-STUDIO3511/4511 ADJUSTMENT
Make a test copy and compare the image obtained with the current settings; if necessary, make
adjustment.
Note:
Remember the image specifications and life span of the replacing parts may not meet the standard when
the setting value is changed from the default value.
<Procedure>
Procedure is same as that of "3.5.2 Density adjustment".
3.5.9 Setting range correction (Adjustment of background peak)
The levels of the background peak for the range correction at a Black Mode can be set at the following
codes.
Make a test copy and compare the image obtained with the current settings; if necessary, make
adjustment.
<Procedure>
Procedure is same as that of "3.5.2 Density adjustment".
3.5.10 Adjustment of smudged/faint text
The smudge/faint text at a Black Mode can be set at the following codes.
Item to be adjusted
Background peak for
range correction
Remarks
When the value increases, the back-
ground (low density area) of the image
is not output.
Acceptable values: 0 to 255.
(Default: Text/Photo: 40, Photo: 16,
Text: 40)
Text/Photo
532
Photo
533
Tex t
534
Original mode
Item to be adjusted
Adjustment of smudged/
faint text
Remarks
When the value increases, the faint text
is improved. When the value decreases,
the smudged text is improved.
Acceptable values: 0 to 255.
(Default: 30)
Text/Photo
648
Original mode
<Adjustment Mode (05)>
<Adjustment Mode (05)>