November 2003 © TOSHIBA TEC 3 - 89 e-STUDIO3511/4511 ADJUSTMENT
3.15 Key Copy Counter (MU-8, MU-10)
To make a key copy counter available, the following 2 components must be installed to the equipment.
Counter socket
MU-10
Key copy counter
MU-8
<Installation procedure>
(1) Take off the right upper cover.
(2) Open the bypass tray, ADU, jam access
cover and fuser unit cover. Take off the IH
terminal cover.
(3) Take off the right rear cover, and cut open
the window for the key copy counter.
(4) Pull out the harness connector from the hole
of the machine frame, and cut the short
harness of the connector. (Treat the cut
harness properly to avoid it causing a short
circuit with the machine frame.) Then,
disconnect the dummy connector.
Right upper cover
Right rear cover
Dummy connector
Harness connector
Fig. 3-1501
Fig. 3-1502
Fig. 3-1503
IH terminal
cover
04/09
To Next Page
Loading...
