Toshiba e-STUDIO3511 - Adjusting the Overlap of the Sensor Flag

November 2003 © TOSHIBA TEC 3 - 73 e-STUDIO3511/4511 ADJUSTMENT
3.13.3 Adjusting the overlap of the sensor flag
If the overlap between the sensor and the flag is wrong for some reason, perform the following adjustment.
(3) Tighten the screw so that the overlap between
the flag of the front/rear jogging rack plate and
the sensor is 1.5 mm to 2.0 mm.
Fig. 3-1308
Fig. 3-1309
Jogging plate
adjusting plate Screw
Adjusting plate
Screw
Jogging plate
adjusting plate
Adjusting plate
Sensor Sensor flag
1.5 mm to 2.0 mm
(1) Remove the processing tray unit.
(2) Loosen the mounting screw of the front/rear
jogging plate adjusting plate; then, move the
adjusting plate to the left and the right.