November 2003 © TOSHIBA TEC 3 - 71 e-STUDIO3511/4511 ADJUSTMENT
AB
(7) Adjust the position of the front jogging plate
home position sensor (S6) with reference to
the index.
EX. 1
If the width is 319 mm in step (2), the
difference from the standard is +2 mm, it
requires relocation of the sensor [3] in the
direction of arrow A by 2 mm.
EX. 2
If the width is 316 mm in step (2), the
difference from the standard is -1 mm; it
requires relocation of the sensor [3] in the
direction of arrow B by 1 mm.
Fig. 3-1304
Screw
Home position
sensor plate
Sensor
Fig. 3-1305
(4) Measure the jogging width (standard at 317
mm).
(5) Remove the processing tray.
(6) Loosen the screw on the home position
sensor plate at the front.
To Next Page
Loading...
