November 2003 © TOSHIBA TEC 3 - 51 e-STUDIO3511/4511 ADJUSTMENT
(2) Installation of lens unit
Follow the procedure below when installing and replacing the lens unit.
<Procedure>
1. Attach the lens unit and fix it temporarily with 2 screws.
2. Match the center scale of the plate in which the unit is to be installed and the rightmost scale
of the adjusting hole on the lens unit plate.
[Front]
Fig. 3-908
3. Tighten 5 screws securely to fix the lens unit while pushing it to the rear side and fix 2 ground
wires with the screws.
Screw
[Rear]
[Rear]
[Front]
Fig. 3-909
Screw
Screw
Screw
Ground wire
Screw
Ground wire
To Next Page
Loading...
