November 2003 © TOSHIBA TEC 3 - 95 e-STUDIO3511/4511 ADJUSTMENT
(10) Turn the adjustment screw fixing bracket in
the direction of an arrow and tighten 1
screw.
Note:
Install the fixing bracket so that the adjustment
screw is caught by the fixing bracket. (The side
face of the fixing bracket and the screw head
become parallel.)
(11) Tighten 2 screws.
Fig. 3-1608
Fig. 3-1609
Fig. 3-1610
(12) Close all covers and drive the main motor for 3 minutes to stabilize the transfer belt.
• While pressing the [0] and [3] button, turn the power ON.
• Key in the code [103] and press the [START] button. (The main motor rotates.)
• Key in the code [151] 3 minutes later and press the [START] button. (The main motor stops.)
05/03
To Next Page
Loading...
