e-STUDIO3511/4511 PREVENTIVE MAINTENANCE 4 - 22 November 2003 © TOSHIBA TEC
*m2. Thermistor
Clean the thermistor with alcohol if the toner or dirt is sticking to it when the fuser roller is
replaced. Do not deform or damage the thermistor during the cleaning. Replace the thermistor
with a new one if it is damaged or deformed regardless of degree.
*m3. Separation roller
When replacing the transfer belt, apply some White Molykote (HP-300) on both ends of the
separation roller shaft.
Fig. 4-218
04/05
To Next Page
Loading...
