Toshiba e-STUDIO3511 - Page 419

November 2003 © TOSHIBA TEC 5 - 105 e-STUDIO3511/4511 TROUBLESHOOTING
3. If the patterns of the leading and trailing edge sides are not aligned, adjust to uniform the
deviation amount of each side. (The top gap of the pattern on the leading edge side and
bottom gap of the pattern on the trailing edge side should be the same. The bottom gap of the
pattern on the leading edge side and top gap of the pattern on the trailing edge side should be
the same.)
(4) Turn the power OFF.
Adjust the image positions of K, C and Y so that the colors do not overlap.
[Details of adjustment area]
Fig. 5-202B
Pattern on the leading edge side
Pattern on the trailing edge side
Equal gap between the image
positions of each color is the
optimal condition.
Optimal condition
[Test pattern]
C
MK
K
Y C
Y
C
MK
C
M
K
K
Y
C
Y
C
M
K
C MK
KY CY
C MK
04/10
Feeding direction
The colors overlap
(Adjustment is needed).
The colors are allowed to con-
tact each other.
Acception
Rejection
Gap: approx. 0.169 mm