e-STUDIO3511/4511 TROUBLESHOOTING 5 - 140 November 2003 © TOSHIBA TEC
(4) Update the version of system ROMs (System Firmware, OS data, UI data) (The ROMs had been
used for the old SYS board).
* See “6. FIRMWARE UPDATING” for the details of System ROM update.
(5) Turn the power OFF and start up with the Setting Mode (08).
(6) When the message “SRAM ERROR DOES IT INITIALIZE?” is displayed on the LCD, press the
[INITIALIZE] button.
* SRAM is cleared
* If SRAM is not performed, F090 error occurs when starting up.
Notes:
• When SRAM is cleared, following items need to be re-set, so make sure the contents of
settings are kept as a record.
<FAX settings>
Terminal ID
Default setting of fax
<E-mail settings>
Setting of properties for E-mail message
<Internet Fax>
Setting of properties for Internet Fax
• When SRAM is cleared, the toner cartridge consumed count of Automatic ordering function of
supplies becomes 0, however, it cannot be re-set.
(7) [If a scrambler board has already been installed]
Perform 08-698 (Entering the key code for scrambler board). Have the user enter the key code.
(8) Perform 08-200 (date and time setting) to set Date/Time.
(9) Turn the power OFF.
* If the FAX board has not been installed, skip to step (13).
(10)Start up with the FAX Clearing Mode (1*)
(11) Perform 1*-102 (Clearing the image data).
Note:
Following image data are deleted when 1*-102 is performed.
- Images of fax polling transmission
- Images of fax Mailbox and box information
- Images of fax transmission
- Images of fax reception
04/09
To Next Page
Loading...
