e-STUDIO3511/4511 FIRMWARE UPDATING 6 - 6 November 2003 © TOSHIBA TEC
(7) “Update Completed!!” is displayed at the bottom of the LCD screen after the updating is completed
properly.
“Update Failed.” is displayed at the bottom of the LCD screen when the updating is not completed
properly. Turn OFF the power, and then check the following items. After confirming and clearing the
problems, restart updating from the beginning.
• Is the download jig connected properly?
• Is the updating data written to the download jig properly?
• Do the download jig and the equipment operate properly?
(8) Turn OFF the power, and then remove the download jig.
(9) Perform the “Updating System ROM” continuously.
6.1.2 PWA-DWNLD-350-JIG1 (16 MB) <Updating System ROM>
To Next Page
Loading...
