e-STUDIO3511/4511 FIRMWARE UPDATING 6 - 22 November 2003 © TOSHIBA TEC
(a) Update Procedure
Since the procedure differs depending on the data, see the each procedure below.
Important:
• Turn OFF the power before installing or removing the download jig.
• Do not turn OFF the power during the update. The data could be damaged and not be operated
properly.
<Updating Engine ROM>
(1) Install the ROM to the download jig.
Make sure the direction is correct ( Page 6-3).
(2) Turn OFF the power of the equipment.
(3) Take off the connector cover.
Connector cover
Cover plate
(4) Remove the cover plate.
To Next Page
Loading...
