November 2003 © TOSHIBA TEC 6 - 33 e-STUDIO3511/4511 FIRMWARE UPDATING
(9) In the FAX Clearing Mode, perform the “FAX Set Up”.
a. Confirm the destination setting is correct in the Setting Mode (08).
08-201: Destination setting of the equipment
08-701: Destination setting of the FAX machine
b. Turn ON the power while [1] button and [*] button are pressed simultaneously.
c. Key in “100”.
d. Press the [START] button.
Note:
If the equipment does not work properly after the operation (9), follow the procedure below and
then perform the “Clearing the image data” in the FAX Clearing Mode to erase the image data in
the memory.
a. Confirm the destination setting is correct in the Setting Mode (08).
08-201: Destination setting of the equipment
08-701: Destination setting of the FAX machine
b. Turn ON the power while [1] button and [*] button are pressed simultaneously.
c. Key in “102”.
d. Press the [START] button.
To Next Page
Loading...
