2.SETTING ITEMS (ADMIN)
Setting Copy Functions 129
2 SETTING ITEMS (ADMIN)
3
Specify the following items as required and press [OK].
AUTOMATIC CHANGE OF PAPER SOURCE — Selecting [ON] for this function allows the equipment to feed the
same size of paper from a different drawer even if the specified drawer from which paper is being fed is empty.
This function is always enabled when copy operations are performed using Automatic Paper Selection (APS). To
learn more about APS, refer to the Copying Guide.
PAPER OF DIFFERENT DIRECTION — Selecting [ON] for this function allows the equipment to feed the same
size of paper that is set in a different direction if the drawer from which paper is being fed is empty.
Paper feeding when the drawer is out of paper during copying is as follows:
This is an example when the drawer for feeding paper is automatically changed while data is being copied on
A4-size paper.
SUSPEND PRINTING IF STAPLER EMPTY — When this is set to [ON], this equipment quit a job with stapling
when the stapler is empty. When this is set to [OFF], this equipment will continue the job without stapling.
DEFAULT MODE OF AUTO COLOR — Press the default color mode for auto color.
[DEFAULT MODE OF AUTO COLOR] is available only for the e-STUDIO6530C Series and e-STUDIO4520C
Series.
Options Paper Feeding
AUTOMATIC CHANGE OF
PAPER SOURCE
PAPER OF DIFFERENT
DIRECTION
Using Automatic Paper
Selection (APS)
Specifying the drawer
manually
ON ON A4 and A4-R paper are fed. A4 and A4-R paper are fed.
ON OFF A4 paper is fed. A4 paper is fed.
OFF ON A4 and A4-R paper are fed. —
OFF OFF A4 paper is fed. —
To Next Page
Loading...
