2 SETTING ITEMS (ADMIN)
82 Setting General Functions
y If you want to clear an entered time, press the [CLEAR] button on the control panel.
y If you want to put the equipment into the sleep (or sleep/super sleep) mode during the entire day, enter the same
time in both the [ON] and [OFF] boxes.
Example) When you enter “0:00” in both the [ON] and [OFF] boxes for [SUN],
the equipment automatically goes into the sleep (or sleep/super sleep) mode at the [OFF] time specified for [SAT].
The sleep (or sleep/super sleep) mode is kept until the [ON] time specified for [MON] comes.
y If you do not want to put the equipment into the sleep (or sleep/super sleep) mode during the entire day, make
settings for the desired day of the week button as follows:
[ON]: 0:00 / [OFF]: 24:00
The equipment does not go into the sleep (or sleep/super sleep) mode during the entire day, which is activated by
the weekly timer function. However, the equipment automatically goes into the sleep (or sleep/super sleep) mode
according to the time value set for [SLEEP MODE] (or the preset time value for activating the sleep (or sleep/super
sleep) mode), if it is left inactive for a certain period of time.
Setting the auto power save mode
1
Press [AUTO POWER SAVE].
The AUTO POWER SAVE screen is displayed.
2
Press the desired period of time (in minutes) that this equipment will wait before the
auto power save mode is activated.
The auto power save mode setting is completed.
To Next Page
Loading...
