2.SETTING ITEMS (ADMIN)
IEEE 802.1X Authentication Setting 155
2 SETTING ITEMS (ADMIN)
4
Confirm the settings and press [APPLY NOW].
The “NETWORK INITIALIZING” message is displayed and this equipment starts initializing the network interface
card to apply the changes.
[CRL Verification] shows whether the certificate revocation list (CRL) is enabled or disabled. To use CRL, it is
necessary to upload the certificate revocation list to the equipment from the TopAccess - Security Service
menu. Changing the CRL verification option from [Enable] to [Disable] or vice versa is also performed from
TopAccess. For details, refer to the TopAccess Guide.
Setting EAP-TTLS
The CA certificate must be installed in this equipment before performing settings for IEEE 802.1X authentication. For
instructions on how to install the certificate, refer to the TopAccess Guide.
1
Select [EAP-TTLS] and press [Next].
The WIRED 802.1X SETTINGS (EAP-TTLS) screen is displayed.
To Next Page
Loading...
