Toshiba E-STUDIO520 - Automatic Feed Copying

e-STUDIO520/600/720/850 GENERAL OPERATION March 2005 © TOSHIBA TEC
4 - 14
4.4.2 Automatic feed copying
Fig.4-5
YES
NO
YES
YES
YES
NO
NO
NO
"CA10"
BC
"E010"
"CA20"
Press [START] button
Process system
control
Transport system
control
Scanning system
control
Is
polygonal motor
ON?
Call for service
Laser ON
Transfer belt bias ON Transport motor OFF
Transfer belt bias OFF
Is H-sync OK?
Call for
service
Is remaining set
number 0?
Laser OFF
Process system
control finished
Transport motor ON
Registration motor ON
Drum separation
finger solenoid ON
Drum separation
finger solenoid OFF
Registration motor OFF
Is fuser unit
transport sensor ON?
Exposure lamp ON
Carriage moving
forward
Carriage stopped
Exposure lamp OFF
Carriage moving
backward
Carriage stopped
Scanning system
control finished
Paper jam
Developer bias ON Fuser motor ON
Main charger ON Developer unit motor ON
Discharge LED ON Transfer belt motor ON
Drum motor ON Used toner transport motor ON
Recycle toner transport motor ON