Toshiba E-STUDIO520 - Disassembly and Replacement

e-STUDIO520/600/720/850 PAPER FEEDING SYSTEM March 2005 © TOSHIBA TEC
9 - 20
9.9 Disassembly and Replacement
[A] Paper feeder unit / Bypass feed unit
(1) Take off the right rear cover
( P.2-45 "[H] Right rear cover")
(2) Open the right center cover to disconnect 1
connector.
Fig.9-12
(3) Remove 2 pins and take off the bypass feed
unit by lifting it and the feeder side center
cover up.
Fig.9-13
(4) Open the right lower cover and take it off by
lifting it up.
(5) Pull out the drawer completely.
Note:
If the drawer is not pulled out completely,
when the paper feeder unit is taken off, the
sensor may get damaged.
Fig.9-14
Bypass feed unit
Pin
Right lower cover