Toshiba E-STUDIO520 - Operation

e-STUDIO520/600/720/850 REVERSING AUTOMATIC DOCUMENT FEEDER (RADF) March 2005 © TOSHIBA TEC
16 - 2
16.2 Operation
Fig.16-2
Apparatus Electric parts
Feeding/transporting section • Jam access cover
• Pickup belt
• Feed roller
• Separation roller
• Registration roller
• Read roller
• Exit/Reverse roller
• Intermediate transport roller
• Small original reverse roller
• Small original exit roller
• Original empty sensor (S60)
• Lifting tray upper limit detection
sensor (S59)
• Lifting tray lower limit detection
sensor (S62)
• Jam access cover open/close
sensor (S61)
• Original length detection sensor
(S63)
• Original registration sensor
(S55)
• Original width detection sensor
1, 2, 3 (S56, 57, 58)
• Read sensor (S69)
• Original intermediate transport
sensor (S70)
• Large original exit sensor (S68)
• Small original reverse sensor
(S66)
• Small original exit sensor (S67)
Original feeding tray • Original feeding tray • Original tray sensor (S53)
• Original tray width sensor (S54)
Drive/control section • Document feed motor (M37)
• Tray lift motor (M38)
• Read motor (M36)
• Large original exit motor (M39)
• Large original exit roller release
solenoid (SOL6)
• Large original exit solenoid
(SOL5)
• Small original exit solenoid
(SOL4)
• RADF open/close sensor (S65)
• APS operation sensor (S64)
• Jam access cover open/close
switch (SW10)
• RADF open/close switch (SW9)
Original feeding tray
Jam access cover
Feeding/transporting section
Large original receiving section
Small original receiving section
Drive/control section