e-STUDIO520/600/720/850 CONTROL PANEL March 2005 © TOSHIBA TEC
5 - 4
5.2.1 Display
No. Message State of equipment Note
1 - Power is OFF (at Sleep Mode) Press [START] button or [FUNC-
TION] button to clear
2 Saving energy - press
START button
At Energy Saving Mode Press [START] button to clear
3 Wait Warming Up Scanner warming up
• Displayed until the equipment
becomes ready to start scanning
Auto Start can be set
4 Wait Warming Up
Auto Start
Scanner warming up
• Displayed when Auto Start is set
Press [STOP] button to clear the
Auto Start
5 WAIT Displayed when performing the con-
trolling function to keep the equip-
ment at the best condition
6 Performing Auto Calibra-
tion
Performing the auto calibration for
the image density
• Displayed when the equipment
has decided to adjust the image
density under certain conditions
and is performing the auto cali-
bration accordingly.
Recovers when the Auto Calibration
has finished
7 READY Ready for copying
• Waiting for the operation
8 READY
Press START button to
copy
Copying job interrupted Press [START] button to resume
copying or press [MEMORY CLEAR]
button to delete the job
9 READY
(WARMING UP)
Scanner warming up
10 Ready
(Performing Auto Calibra-
tion)
Ready for scanning
• Displayed when the equipment is
ready for scanning and waiting for
the operator to select the copying
conditions.
Performing the auto calibration
11 READY
(PRINTING)
Printing out the data
• Scanning is enabled
12 READY
(ADD INSERTER PAPER)
Ready for scanning
• The equipment is ready for scan-
ning and waiting for the operator
to select the copying conditions.
No inserter paper
Printing is resumed when the
[START] button is pressed under the
condition the printing UI is displayed
([JOB STATUS] button pressed) after
adding inserter paper.
13 READY
(ADD TAB SHEET)
Ready for scanning
• The equipment is ready for scan-
ning and waiting for the operator
to select the copying conditions.
No tab paper
Printing is resumed when the
[START] button is pressed under the
condition the printing UI is displayed
([JOB STATUS] button pressed) after
adding tab paper.
14 READY
(FINISHER IN USE)
Ready for scanning
• The equipment is ready for scan-
ning and waiting for the operator
to select the copying conditions.
Finisher manual operating
Printing is started when pressing the
[START] button.
15 READY
(CHECK STAPLER)
No staples in finisher
• Scanning is enabled
Cleared by supplying the staples
16 READY
(CHECK STAPLER)
Stapling jam occurred in finisher
17 READY (ADD PAPER)
Press JOB STATUS button
No paper in drawer
• Scanning is enabled
Cleared by supplying papers
To Next Page
Loading...
