2
March 2005 © TOSHIBA TEC e-STUDIO520/600/720/850 OUTLINE OF THE MACHINE
2 - 43
2.5 Installation and Replacement of Covers
[A] Front cover (Upper/Lower)
[B] Front right inner cover
(1) Open the front cover (upper). Turn 2 hinge
pins to point at the front side and pull them
out upward. Then take off the front cover
(upper).
Fig.2-33
(2) Open the front cover (lower). Then take off
the cover by lifting it up.
Fig.2-34
(1) Take off the front cover
( P.2-43 "[A] Front cover (Upper/Lower)").
(2) Remove 2 screws to take off the front right
inner cover.
Fig.2-35
Front cover
(
upper
)
Front cover
(
lower
)
Front right inner cover