Toshiba E-STUDIO520 - Disassembly and Replacement

12
March 2005 © TOSHIBA TEC e-STUDIO520/600/720/850 DEVELOPER UNIT
12 - 15
12.6 Disassembly and Replacement
[A] Toner cartridge drive unit
[A-1] Toner cartridge drive unit
[A-2] Toner cartridge switch (SW2)
(1) Take off the right front inner cover.
( P.2-43 "[B] Front right inner cover")
(2) Disconnect 1 connector.
(3) Loosen 1 screw to take off the bracket.
(4) Pull down the fixing pin and rotate it by 90º.
Fig.12-9
(5) Pull out the toner cartridge drive unit up to
approx. 30º, and then take it off in the direc-
tion of the arrow.
Fig.12-10
(1) Disconnect 2 connectors, remove 1 screw,
and then take off the toner cartridge switch
with the bracket.
(2) Remove 2 screws to take off the toner car-
tridge switch.
Fig.12-11
Fixing pin
BracketScrew
Toner cartridge drive unit
Top cover
Toner cartridge detection switch
Screw
Screw