Toshiba E-STUDIO520 - Page 262

e-STUDIO520/600/720/850 DEVELOPER UNIT March 2005 © TOSHIBA TEC
12 - 16
[A-3] New toner supply motor (M5)
[A-4] Toner cartridge empty sensor (S10)
[A-5] New toner transport motor (M6)
(1) Remove 3 screws to take off the top cover.
(2) Disconnect 1 connector, remove 2 screws,
and then take off the new toner supply motor.
Fig.12-12
(1) Remove 2 screws, and then take off the
toner cartridge empty sensor with the har-
ness.
(2) Disconnect 1 connector from the toner car-
tridge empty sensor.
Note:
Be careful not to damage the sensor when
connecting and disconnecting the connector.
Fig.12-13
(1) Remove 3 screws to take off the top cover.
Fig.12-14
New toner supply motor
Connector
Screw
Toner cartridge empty sensor
Top cover
Screw
Screw