16
March 2005 © TOSHIBA TEC e-STUDIO520/600/720/850 REVERSING AUTOMATIC DOCUMENT FEEDER (RADF)
16 - 19
13)After the original trailing edge has passed the 3rd roller
The large original exit motor (M39) stops rotating when the trailing edge of the original has been
detected by the original intermediate transport sensor (S70) then proceeded a specified distance.
The small original exit motor (M40) starts to slow down when the trailing edge of the original has
come to a specified distance before the small original reverse sensor (S66). Then it stops rotating
when the trailing edge of the original has been detected by the small original reverse sensor (S66)
and proceeded a specified distance.
Fig.16-34
The small original exit motor (M40) starts to rotate forward. Then it starts to slow down with a speci-
fied time delay after the small original reverse sensor (S66) has detected the leading edge of the
original.
Fig.16-35
The small original exit motor (M40) stops rotating when the trailing edge of the original has been
detected by the small original exit sensor (S67) then proceeded a specified distance. The small orig-
inal exit solenoid (SOL4) turns OFF and the operation ends when the original has been discharged.
Fig.16-36
To Next Page
Loading...
