e-STUDIO520/600/720/850 REVERSING AUTOMATIC DOCUMENT FEEDER (RADF) March 2005 © TOSHIBA TEC
16 - 88
[D-2] Separation roller
(4) Remove 1 clip to pull out the shaft.
(5) Remove 1 clip to pull out the shaft, and then
take off the pickup belt.
(6) Remove 1 clip to pull out the shaft, and then
take off the feed roller.
Notes:
1. There are 3 types of clips with different
sizes.
2. Be sure to install the feed roller in the
proper direction.
Fig.16-116
(1) Take off the pickup unit
( P.16-87 "[D-1] Pickup belt / Feed roller").
(2) Remove 2 screws to take off the upper guide
unit.
Fig.16-117
(3) Remove 2 screws to take off the paper sepa-
rating unit.
Fig.16-118
Metal bushing
Pickup belt
Feed roller
Clip
(
large
)
Clip
(
small
)
Clip
(
middle
)
Upper guide unit
Screw
Screw
Paper separating unit
Screw
To Next Page
Loading...
