2
March 2005 © TOSHIBA TEC e-STUDIO520/600/720/850 OUTLINE OF THE MACHINE
2 - 33
M25 REV-FAN-MOT2
Reverse section cooling
fan-2
Cooling down the reverse section
(front side)
Fig.2-17 15-12
M26 IH-FAN-MOT
IH board cooling fan
Cooling down the IH board Fig.2-18 24-17
M27 DCT-O-FAN-MOT
Duct out fan
Suctioning ozone generated at charging Fig.2-18 33-3
M28 FUS-FAN-MOT
Fuser cooling fan
Cooling down the fuser Fig.2-18 33-3
M29 EXIT-FAN-MOT
Exit section cooling fan
Cooling down the exit section Fig.2-18 33-3
M30 DCT-I-FAN-MOT
Duct in fan
Cooling down the developer unit Fig.2-19 42-25
M31 DEV-FAN-MOT
Developer unit fan
Suctioning toner Fig.2-19 42-13
M32 LSU-FAN-MOT
Laser unit cooling fan
Cooling down the laser unit Fig.2-19 32-9
M33 SYS-FAN-MOT
SYS board cooling fan
Cooling down the SYS board and hard disk Fig.2-23 54-8
M34 PS-FAN-MOT1
Switching regulator cool-
ing fan-1
Cooling down the switching regulator
(rear side)
Fig.2-23 52-14
M35 PS-FAN-MOT2
Switching regulator cool-
ing fan-2
Cooling down the switching regulator
(lower side)
Fig.2-23 52-14
M36 DF-READ-MOT
Read motor
Driving the read roller for originals Fig.2-30 83-27
M37 DF-FEED-MOT
Document feed motor
Driving the feed roller, pickup belt and reg-
istration roller for originals
Fig.2-30 86-19
M38 DF-TRY-MOT
Tray lift motor
Driving the original lifting tray Fig.2-30 86-20
M39 DF-L-EXIT-MOT
Large original exit motor
Driving the large original exit roller and the
intermediate reverse roller
Fig.2-30 87-14
M40 DF-S-EXIT-MOT
Small original exit motor
Driving the small original exit roller and the
small original reverse roller
Fig.2-30 87-13
M41 LCF-TRY-MOT
Tandem LCF tray-up motor
Lifting up the tray in the tandem LCF
(Only for ASD/ASU/AUD/MJD/CND/KRD
model of all equipments and TWD model of
e-STUDIO850)
Fig.2-22 31-34
M42 LCF-ENDF-MOT
Tandem LCF end fence
motor
Driving the end fence in the tandem LCF
(Only for ASD/ASU/AUD/MJD/CND/KRD
model of all equipments and TWD model of
e-STUDIO850)
Fig.2-22 9-22
Symbol Name Function Remarks P-I
05/07
To Next Page
Loading...
