e-STUDIO520/600/720/850 GENERAL OPERATION March 2005 © TOSHIBA TEC
4 - 4
7) Paper exit
# The exit sensor (S22) detects the trailing edge of the paper.
# The equipment enters the toner supply operation when developer material toner density is lower
than the preset value.
# The main charger, developer bias and discharge LED (ERS) are turned OFF.
# The drum, transfer belt, fuser unit and developer unit stop. Each fan returns to the ready rotation.
# The feed motor (M20) is turned OFF.
# The rotation speed of the polygonal motor (M2) switches from a high speed to a low speed.
(e-STUDIO520/600/720)
# "READY" appears and the equipment enters the ready state.
To Next Page
Loading...
