Toshiba E-STUDIO520 - Setting the Weekly Timer

4
March 2005 © TOSHIBA TEC e-STUDIO520/600/720/850 GENERAL OPERATION
4 - 9
• When the power is turned ON or the feed unit performs initialization.
!
Detecting the presence of paper
- The tray-up motor (M21, 22) is turned ON. # The tray goes up.
# When the drawer tray-up sensor (S32, 38, 44, 50) is not turned ON within a fixed period of time, it
means that the tray is in an abnormal condition. # "Add paper" appears regardless of whether
paper is on the tray or not.
- It is cleared by turning the power ON/OFF.
# The drawer tray-up sensor (S32, 38, 44, 50) is turned ON within a fixed period of time.
# The tray-up motor (M21, 22) stops.
- At this time, if the drawer empty sensor (S31, 37, 43, 49) is ON: It is judged that there is paper
OFF:
It is judged that there is no paper.
!
The drawer area of the LCD panel blinks (when the drawer is selected).
• Paper in the drawer runs out during copying.
!
The drawer tray-up sensor (S32, 38, 44, 50) is turned OFF
!
The tray-up motor (M21, 22) is turned ON # The tray goes up.
!
The drawer tray-up sensor (S32, 38, 44, 50) is turned ON # The tray-up motor (M21, 22) stops.
• The drawer empty sensor (S31, 37, 43, 49) is turned OFF during the copying although the drawer
tray-up sensor (S32, 38, 44, 50) is ON.
!
It is judged that there is no paper.
!
The drawer area of the LCD panel blinks (when the drawer is selected).
!
The copying operation stops.
(B) Pick-up failure in bypass
• During bypass feeding
The bypass pickup solenoid (SOL3) is turned ON.
!
The registration sensor (S18) is turned ON.
# The registration sensor (S18) is not turned ON within a fixed period of time.
!
Pick-up failure in bypass
!
The clear paper symbol is displayed: E120
!
Copying operation is disabled.
!
Solution: Remove the paper from the bypass tray. # The bypass paper sensor (S27) is turned OFF.