Toshiba e-studio905 - Connecting to the Ethernet Interface

Connecting to the Ethernet Interface
This section describes how to connect Ethernet interface cable to the Ethernet interface.
• If the main power switch is on, turn it off.
• Use the following Ethernet cables.
• Unshielded Twisted Pair Cable (UTP) or Shielded Twisted Pair Cable (STP) and Category type
5 or more
1. Make sure the main power switch of the machine is off.
2. Connect the Ethernet interface cable to the 10BASE-T/100BASE-TX port.
CCJ002
3. Connect the other end of the Ethernet interface cable to a network connection device such
as a hub.
4. Turn on the main power switch of the machine.
BRV035S
1
2
1. Indicator (green)
Lights up green when the machine is connected correctly to the network.
2. Indicator (yellow)
Lights up yellow when 100 BASE-TX is in operation. Goes off when 10 BASE-T is in operation.
3. Connecting the Machine
102
3