help
Use the "help" command to display the available command list and the procedures for using those
commands.
Command list display
msh> help
Display of procedure for using commands
msh> help "command_name"
hostname
Use the "hostname" command to change the printer name.
View settings
msh> hostname
IPv4 Configuration
msh> hostname "interface_name" "printer_name"
• Enter the printer name using up to 63 alphanumeric characters.
• You cannot use a printer name beginning "RNP" (in either upper or lower case).
• If you do not specify an interface, the Ethernet interface is selected automatically.
Interface name Interface configured
ether Ethernet interface
Initializing the printer name for each interface
msh> hostname "interface_name" clear name
ifconfig
Use the "ifconfig" command to view and configure TCP/IP (IP address, subnet mask, broadcast address,
default gateway address) for the printer.
View settings
msh> ifconfig
IPv4 configuration
msh> ifconfig "interface_name" "parameter" "address"
• If you did not enter an interface name, it is automatically set to the Ethernet interface.
Remote Maintenance by telnet
187
To Next Page
Loading...
