Setting login mode for NDS tree name
msh> netware tree "NDS tree name"
File transfer protocol
msh> netware trans {ipv4pri|ipxpri|ipv4|ipx}
• If you do not specify the protocol, the current setting is displayed.
Protocol Set Protocol
ipv4pri IPv4+IPX (IPv4)
ipxpri IPv4+IPX (IPX)
ipv4 IPv4
ipx IPX
passwd
Use the “passwd” command to change the remote maintenance password.
Changing the password
msh> passwd
• Enter the current password.
• Enter the new password.
• Re-enter the new password to confirm it.
Changing the password of the administrators using the Supervisor
msh> passwd {Administrator ID}
• Enter the new password.
• Re-enter the new password to confirm it.
• Be sure not to forget or lose the password.
• The password can be entered using up to 32 alphanumeric characters. Characters are case-sensitive.
For example, “R” is not the same as “r”.
pathmtu
Use the "pathmtu" command to display and configure the PathMTU Discovery service function.
5. Monitoring and Configuring the Printer
192
To Next Page
Loading...
