Setting the Domain Name
msh> domainname "interface_name" name "domain name"
• A domain name can be entered using up to 63 alphanumeric characters.
Interface Interface set
ether Ethernet interface
Deleting the Domain Name
msh> domainname "interface_name" clear name
etherauth
Use the "Ethernet" command to display or modify the authentication related parameters for Ethernet.
View settings
msh> etherauth
802.1x Configuration
msh> etherauth 8021x {on|off}
• {on} means "active" and {off} means "inactive".
etherconfig
Use the "etherconfig" command to view and configure the Ethernet parameters.
View settings
msh> etherconfig
Specify Ethernet Speed
msh> etherconfig speed {auto|10f|10h|100f|100h}
• auto = Auto Select
• 10f = 10 Mbps Full Duplex
• 10h = 10 Mbps Half Duplex
• 100f = 100 Mbps Full Duplex
• 100h = 100 Mbps Half Duplex
The default is "auto".
5. Monitoring and Configuring the Printer
186
To Next Page
Loading...
